Skyward Telecom

  Dell PowerEdge R760  is a rack or tower server appropriate for attended data center environment. However, lower acoustical output is attainable with proper hardware or software configurations. Configurations tested for acoustical experience

  Lenovo has returned to the broadest range of products since buying IBM's System x portfolio and has redesigned its ThinkSystem servers from the ground up. They offer a wealth of new features, and in this exclusive review, we get our first look at the  ThinkSystem SR650  general-purpose 2U rack server. Support for the Intel Xeon Scalable CPU family is at the top of Lenovo's agenda, and the SR650 showcases a new storage design that offers more options. The SR650 supports up to 14 LFF or 24 SFF drives and comes standard with embedded NMVe PCI-Express ports, while previous generations of AnyBay carriers added storage versatility. A welcome update for us is Lenovo's embedded XCC (xClarity Controller) chip. Remote server management has been a major weakness of the current System x and ThinkServer platforms, and XCC ties it in tightly with Dell's iDRAC9 and HPE's iLO5. manage The first benefit of the ThinkSystem firmware became apparent when we powered the ...

 How to Remove and Install the Fan Board on Dell R750xs ? The below video will guide you to replace or install the fan board on Dell poweredge R750xs rack server. Before You Begin Power off the system, disconnect all the attached peripherals of the R750xs. Ensure that you always use ESD protection when working inside the system.

How to configure network settings using Lifecycle Controller? Just follow these steps to configure network settings using Lifecycle Controller. 1, Launch the Lifecycle Controller. 2, On the left pane, click Settings. 3, On the Settings pane, click Network Settings. 4, From the NIC Card drop-down menu, select the NIC port that you want to configure, You can use only one NIC at a time to communicate with the network. 5, From the IPV4 Network Settings→ IP Address Source drop-down menu, select one of the following options: No Configuration—indicates that the NIC must not be configured. DHCP—indicates that the NIC must be configured using an IP address from a DHCP server. If DHCP is selected, a DHCP IP address is displayed on the Network Settings page. Static IP—indicates that the NIC must be configured using a static IP. Type the IP Address Properties—IP Address, Subnet Mask, Default Gateway, and DNS Address. If you do not have this information, contact your network administrator. 6, From ...